Seismic certified to the following codes and standards: 2007 & 2010 CBC; 2006, 2009 & 2012 IBC; ASCE 7-05 (2005 Edition) & ASCE 7-10 (2010 Edition) and the 2006 & 2009 editions of NFPA 5000 for use in areas of high seismicity – Zone 4 or Seismic Design Category (SDC) "D". These are designed for Mission Critical and/or High-Importance Installations in locations with the highest level of seismicity and top floor or rooftop installations including those within UBC and CBC Essential facilities or IBC, ASCE 7, and NFPA 5000 Seismic Use Group III facilities. For all codes, the Importance factor (Ip) is 1.5. Seismic Certified load capacity of 600 lbs. when used with ERK-Z4 seismic floor anchor brackets.
1/2", 3/4", 1" and 1-1/2" electrical knockouts found on removable split rear plates, top knockout plate additionally includes UHF/VHF antenna knockouts
16-gauge steel tops, bottoms, & sides
Laser-cut 1/8" thick internal steel braces for strength
1 pair fully-adjustable front rackrail
Large cable entry in bottom
Grounding and bonding stud installed in base
Configurable top (44, 40, 35 sp.), solid top with fan KO’s (27, 21, 18 sp.)
Laser KO’s in side panels for cable pass-through (44, 40, 35 sp. only)
Seismic certified to the following codes and standards: 2007 & 2010 CBC; 2006, 2009 & 2012 IBC; ASCE 7-05 (2005 Edition) & ASCE 7-10 (2010 Edition) and the 2006 & 2009 editions of NFPA 5000 for use in areas of high seismicity – Zone 4 or Seismic Design Category (SDC) "D". These are designed for Mission Critical and/or High-Importance Installations in locations with the highest level of seismicity and top floor or rooftop installations including those within UBC and CBC Essential facilities or IBC, ASCE 7, and NFPA 5000 Seismic Use Group III facilities. For all codes, the Importance factor (Ip) is 1.5. Seismic Certified load capacity of 600 lbs. when used with ERK-Z4 seismic floor anchor brackets.
1/2", 3/4", 1" and 1-1/2" electrical knockouts found on removable split rear plates, top knockout plate additionally includes UHF/VHF antenna knockouts
16-gauge steel tops, bottoms, & sides
Laser-cut 1/8" thick internal steel braces for strength
1 pair fully-adjustable front rackrail
Large cable entry in bottom
Grounding and bonding stud installed in base
Configurable top (44, 40, 35 sp.), solid top with fan KO’s (27, 21, 18 sp.)
Laser KO’s in side panels for cable pass-through (44, 40, 35 sp. only)